KnuckleBustingTwin
Veteran Member
Hey Gang,
Hope all are well! ... I recently bought this JT sprocket for my CB500T build and the mounting holes are too small (10mm vs 12mm) ... this wasn't originally noted on the Dime City page, although it is now after my complaint. I am considering just drilling out the holes to 12mm to make it work and to save time on the return, but I am wondering if drilling the holes could potentially weaken the structure of the sprocket significantly. I'm no expert, but I am inclined to think probably not ... before I did it though, I thought I would run it by the group ... any thoughts?
Here's the link ... https://www.dimecitycycles.com/vint...oth-honda-cb500t-rear-sprocket-jtf280-33.html
Thanks Bill
*Update; Just purchased a 15/32 metal drill it ... going to give it a try ...
Hope all are well! ... I recently bought this JT sprocket for my CB500T build and the mounting holes are too small (10mm vs 12mm) ... this wasn't originally noted on the Dime City page, although it is now after my complaint. I am considering just drilling out the holes to 12mm to make it work and to save time on the return, but I am wondering if drilling the holes could potentially weaken the structure of the sprocket significantly. I'm no expert, but I am inclined to think probably not ... before I did it though, I thought I would run it by the group ... any thoughts?
Here's the link ... https://www.dimecitycycles.com/vint...oth-honda-cb500t-rear-sprocket-jtf280-33.html
Thanks Bill
*Update; Just purchased a 15/32 metal drill it ... going to give it a try ...
